Idiomas disponibles
Idiomas disponibles
Safety precaution:
• S p e c i a l i s t t e c h n i c a l k n o w l e d g e a n d /
o r
s u i t a b l e
for the use and repair of this tool.
• The tool was developed and manufactured accord-
ing to the technical norms and standards valid at
the time and is considered to be operationally reli-
able. Nevertheless, the tool can present a danger
when it is not used as intended or in an inappropri-
ate way by non-qualified personnel. Please make
sure that any person using this tool or carrying
out any maintenance work carefully reads these
operating instructions and fully understands all the
provided information before using the tool.
• Keep the operating instructions together with the
tool at all times. If the operating instructions have
been mislaid or made unusable, please contact
your specialist dealer or HAZET-WERK.
• Only operate the tool if it is in good working condi-
tion. If the tool does not work properly, it must be
removed from service and inspected.
• All safety, warning and operation instructions on
the tool must remain legible. Any damaged labels
or stickers, as well as the display cover, must be
replaced immediately.
• In addition to the safety advice given in these
operating instructions, the general safety
regulations, accident prevention regulations and
environmental protection regulations relevant to
the application of this tool are to be observed and
adhered to.
• All safety equipment must always be within reach
and should be checked regularly.
20
For your safety
1
t r a i n i n g
i s
r e q u i r e d
2. Intended use
Operational reliability can only be ensured,
if the tool is used as intended and in
compliance with the indications given in the
operating instructions. Any deviation from
the intended use and/or any misapplication of the
tool is not allowed and will be considered as improper
use.
Use and maintenance of the tool must always comply
with relevant national or federal regulations.
Incorrect use, use whilst failing to comply with the
safety instructions and overloading of the HAZET
torque tester can result in incorrect readings and/
or failure of the system (and therefore death, serious
injury, health problems and material damage).
Never modify the tool. For safety reasons, any modifi-
cation of the HAZET torque tester is strictly forbidden.
Do not remove safety devices and/or housing parts.
Never operate the tool if a protective cover is miss-
ing or if not all of the safety devices are fitted and in
perfect working order.
The maximum permissible torque must not be ex-
ceeded. All indications concerning threshold values,
setting values and setting ranges must be observed.
Any claims against the manufacturer and/or its
authorised agents because of damage caused by
improper use of the tool are void. Any modification of
the tool and/or improper use will result in immediate
exclusion from warranty and liability. Any personal
injury or material losses caused by improper use of
the tool are the sole responsibility of the owner.
