Skil 2714 Manual Original página 14

Recharge the tool.
• Changing the angle of the pivot head w
• Automatic spindle-lock
Allows you to manually tighten or loosen
screws, when necessary
•
Battery protection
Switches off the tool or prevents the tool
from being switched on, when
- the load is too high
- the battery temperature is not within the
allowable operating temperature range
of 4...50°C
- the lithium-ion battery is nearly empty (to
protect against deep discharge)
! do not continue to press the
switch E after the tool is switched
off automatically; battery may be
damaged
APPLICATION ADVICE
• Always use the correct type and size of bit
for the application. e
! do not use damaged bits
• Drill a pilot hole when driving fastener
in hard wood, or at or near the cross cut
end or an edge of wood, in order to avoid
cracking of the wood.
• Only apply the tool to the fastener when
the tool is switched off. Rotating bits can
slip off and damage the fastener head.
• It is recommended to perform the first
few turns manually by hand, key, or a
screwdriver to ensure the correct driving of
a fastener.
• In case of working with threaded
components, do not exert too much
pressure on the tool. This can lead to the
damage of the thread.
• Always hold the tool bit perpendicularly
aligned with the fastener. Holding it at an
angle may cause slipping or jamming of
the fastener.
• Driving and removing screws r
• For more information see www.skil.com
MAINTENANCE / SERVICE
• This machine is not intended for
professional use
• Always keep tool clean
• If the tool should fail despite the care taken
in manufacturing and testing procedures,
repair should be carried out by an after-
sales service centre for SKIL power tools
- send the tool undismantled together
with proof of purchase to your dealer
or the nearest SKIL service send the
tool undismantled together with proof of
purchase to your dealer or the nearest
SKIL service station (addresses as well
as the service diagram of the tool are
listed on www.skil.com)
• Be aware that damage due to overload
or improper handling of the tool will be
excluded from the warranty (for the SKIL
warranty conditions see www.skil.com or
ask your dealer)
ENVIRONMENT
Only for EU countries
• Do not dispose of electric tools,
accessories and packaging together
with household waste material
- in observance of European Directive
2012/19/EC on waste of electric
and electronic equipment and its
implementation in accordance with
national law, electric tools that have
reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling
facility
- symbol 4 will remind you of this when
the need for disposing occurs
! remove the batteries before disposal
of the tool
Only for UK countries
• Do not dispose of electric tools,
accessories and packaging together
with household waste material
- in observance of on Waste Electric and
Electronic Equipment Regulations 2013
(SI 2013/3113), electric tools that have
reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling
facility
- symbol 4 will remind you of this when
the need for disposing occurs
! remove the batteries before disposal
of the tool
• Removing/disposing of batteries
! integrated batteries may only be
removed for disposal by qualified
personnel
! only remove the batteries if they are
completely empty
14