Idiomas disponibles
Idiomas disponibles
CAUTION:
Use personal protective equip-
ment such as a dust mask and eye protection.
NOTE: Point the nozzle at an angle according to the
outlines of the filter so the adhered dust can be easily
removed.
Blowing wide and open area
Recommended nozzles
—
Wide range nozzle
Blow air over dirt and liquid on wide-open surfaces such
as desktop and floor, using the five-hole nozzle with 120
degree range of blowing.
Direct the nozzle over a large area within a certain
distance and swing it back and forth and from side to
side to blow widely.
Fig.30
CAUTION:
Use personal protective equip-
ment such as a dust mask and eye protection.
Inflating plastic inflatables
Recommended nozzles
—
Pinch valve nozzle
—
Nozzle 13
Inflatable air volume with fully charged battery
cartridge BL1860B without recharging it
Inflatable air
volume
Air volume mode
(With pinch valve
nozzle)
4: Max
13.0 m
3: High
13.4 m
2: Medium
15.6 m
1: Low
22.8 m
NOTE: The maximum output air pressure of this tool
is 20.2 kPa (2.9 PSI).
(With nozzle 13)
Number of ø61
cm (ø24") plastic
beach balls equiv-
alent in air volume
(With pinch valve
nozzle)
3
(459 cu.ft.)
110
3
(473 cu.ft.)
115
3
(551 cu.ft.)
130
3
(805 cu.ft.)
190
Inflate beach toys, pillows, and similar small plastic
inflatables with pinch valve nozzle.
Inflate garden pools, air mattresses, and similar large
plastic inflatables with nozzle 13.
Insert the nozzle into an air inlet on an inflatable item
and pull the switch trigger to start inflating.
Slowly release the switch trigger to reduce air volume
as the inflatable item comes close to fully inflated.
Remove the nozzle from the air inlet after stopping the
air flow and then close the air inlet.
Fig.31
Fig.32
CAUTION:
Always be careful not to over-in-
flate inflatables during operation. It otherwise may
burst the inflatables, possibly causing damage to the
tool and personal injury.
CAUTION:
Never leave the tool unattended
while the nozzle is attached to inflatables or
during operation.
CAUTION:
Be aware that heated air stream
may flow through the air vent hole at bottleneck
of the pinch valve nozzle due to air circulation.
NOTE: Make sure to insert the pinch valve nozzle
fully through the air inlet so the nozzle head serves to
open the flap valve inside the air inlet.
NOTE: For an inflatable item with a small air inlet
opening, insert the narrow tip of the pinch valve noz-
zle in the air inlet until the bottleneck of the nozzle
head touches the rim of the air inlet.
NOTE: For an inflatable item with a large air inlet
opening, insert the pinch valve nozzle head fully into
the air inlet to open the flap valve inside the air inlet.
18 ENGLISH
