Eldom SD210B Manual De Instrucciones página 10

Mode
Clean
White
Gum Care
USE
• Put the tip (9) on the stem (1) - Fig. 1.
• Wet the bristles on the tip (9).
• Apply a small amount of toothpaste to the wet bristles.
• Select the operation mode using the button (5) and switch on the appliance using the button
(3).
• Select the vibration intensity using the button (5).
• Insert the toothbrush into the mouth and position it at a suitable angle (Fig. 4) and switch
on.
• Brush the teeth in a circular motion, gently moving the brush head over each section of the
teeth (Fig. 3) for 10 seconds, including the front, back and gum surfaces.
• Do not press the device too hard against the teeth and gums.
• The cleaning cycle lasts 2 min. The toothbrush will generate a pulse every 30s.
• When the set time has elapsed, the device will switch off automatically.
• The device operation can be interrupted at any time using the switch (3).
• Rinse your mouth after brushing is complete. A specialised mouthwash can be used.
• Remove the brush head (9), wash it thoroughly and set aside to dry.
• Wipe off the appliance and place it in a dry place or on the charging station (10).
TEETH CLEANING – RECOMMENDATIONS
• Divide the teeth into 4 areas – Fig. 3.
• Brush each part for approximately 30 seconds
• The toothbrush signals when the time is up.
• Apply the head bristles to the teeth correctly – Fig. 4
CLEANING AND MAINTENANCE
• Clean the appliance after each use.
• Before cleaning, make sure the device is turned off.
• Do not immerse the charging station (10) in water.
• Do not use strong agents, cleaning agents or cleaning products which may damage the surface.
• Wipe the charging station (10) and housing (2) with a damp cloth.
• Rinse the head (9) thoroughly. Do not compress or pull the bristles to avoid damage.
PROBLEMS AND SOLUTIONS
Problem
The head vibrations are
too weak
The head vibrations are
too weak
Operating time is short
The toothbrush does
not work
10
Method of operation
Daily plaque removal
Removes plaque, whitens front teeth and
eliminates discolouration
Polish and massage gums
Possible cause
The bristles are too tightly pressed against
the teeth
The toothbrush is not sufficiently charged:
1. It is incorrectly placed on the charging
station or not in the proper spot, which
causes the charging function to fail
2. The charging station is not connected to
the mains.
1. The toothbrush is not charged.
2. The toothbrush has been damaged.
Operating time
Two minutes, impulse
every 30 seconds
Solution
Press the toothbrush gently against
the teeth
1. place the toothbrush on the
charging station properly,
2. check the connection of the
charging station to the mains.
1. Charge the toothbrush.
2. Contact the manufacturer's
maintenance service.