Olimpia splendid MYSTRAL E Instrucciones Para El Uso Y El Mantenimiento página 66

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 149
REMOTE CONTROL 
SELF‐CLEAN function
Only optional for some heating pump inverter
appliance. To active this function, turn off the
indoor unit at first, then press
button at the same time toward the indoor
SWING
unit, until hear a beep, and
on the remote controller display and the indoor
LED display.
1. This function helps carry away the accumulated
dirt, bacteria, etc from the indoor evaporator.
2. This function will run about 30 minutes, and it
will return to the pre‐setting mode. You can
press 
button to cancel this function during
the process. 
You will hear 2 beeps when it's finished or 
cancelled. 
It's normal if there is some noise during this
function process, as plastic materials expand
with heat and contract with cold.
We suggest operating this function at the
following ambient conditions to avoid the
activation of the safety devices.
Indoor unit 
Temp <  86
Outdoor unit 
41
F (5
o
It's suggested to utilize this function every 
3 months. 
8
C heating function 
o
1.
Long press 
ECO 
button over 3 seconds to active 
this function, and  8 C  (  46 F 
the remote display. 
Do it again to deactivate 
2. This function will auto start the heating mode
when the room temperature is lower than 8
(46
o
F), and it will return to standby if the
temperature reaches 9
3. If the room temperature is higher than 18
(64
F), the appliance will cancel this function
o
automatically.
and
SWING
will appear
AC 
o
F (30
o
C) 
C) < Temp < 86
F (30
C) 
o
o
o
) will appear on 
this function. 
o
C
o
C (48
o
F).
o
C
I SET function
Remember your favorite setting and run into it by
press One button
Remember the favorite setting:
1. In each mode (COOLING/ HEATING/ FAN/ DRY),
long press " I SET " button over 3 seconds to
remember it;
2. When "AU" flashing appears on the remote
controller display, that means the remote
controller remember your favorite setting;
* Press any button to quit, and you can reset it
by repeat 1, 2 operation.
Run into the favorite setting:
1.
In each mode (COOLING/ HEATING/ FAN/ DRY),
one press " I SET " button to active;
2.
The appliance will run as your favorite setting
and you will see [AU] flashing on the remote
controller;
3. Press it again or other buttons to cancel this
function.
12 
EN - 20
loading