Injuries caused by prolonged use of a tool.
When using any tool for prolonged periods ensure you
take regular breaks.
Safety of others
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
Labels on tool
The label on your tool may include the following symbols:
WARNING! To reduce the risk of injury, the user
must read the instruction manual before use.
Wear safety glasses or goggles.
Wear ear protection.
Wear a dust mask.
Wear gloves when handling blades.
Do not stare at operating lamp
V
Volts
A
Amperes
Hz
Hertz
W
Watts
min
minutes
Alternating
Current
Position of date code
The Date Code, which also includes the year of manufacture, is
printed into the housing.
Example:
2023 XX JN
Year of manufacturing
Direct Current
n
No-Load Speed
0
Class II
Construction
Earthing Terminal
Safety Alert
Symbol
/min.
Revolutions or
Reciprocation per
minute
(Original instructions)
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not store in locations where the temperature may
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
40 °C.
Charge only using the charger provided with the tool.
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
p
Do not attempt to charge damaged batteries.
Chargers
Use your Stanley Fat Max charger only to charge the
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The charger is intended for indoor use only.
$
Read the instruction manual before use.
+
Electrical safety
i
Your charger is double insulated; therefore no
earth wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit
with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised STANLEY Service Centre
in order to avoid a hazard.
Warning! Never attempt to replace the charger unit
@
with a regular mains plug.
Features
This tool includes some or all of the following features.
1. Battery pack
2. Battery release button
3. On/Off switch
4. Variable speed dial
5. Depth adjustment knob
6. Motor unit
ENGLISH
25