Idiomas disponibles
Idiomas disponibles
Installation (continued)
9
Removing the plastic cap
□
Before installing the escutcheon (E), remove the
plastic cap (1) from the valve body (D) by twisting
the cap in a clockwise direction.
10
Adjusting the temperature
NOTE: The limiter on the valve can be set to allow partial or full access to hot water by limiting how far the handle can be turned to the
hot side of the valve. The limiter is typically set at the factory to allow only warm water to pass through the valve. Follow the directions
in this section if you wish to adjust the amount of hot water that is allowed through the valve. If you do not wish to adjust the amount
of hot water that is allowed through the valve, proceed to the step 11, and skip over the step 10 (A, B, C, D).
A
Removing the sleeve and
inverter
□
Unscrew the sleeve (1) from the valve body (D).
□
Unscrew the screw (2) from the inverter (3),
and then remove the inverter (3) from the
valve body (D).
3
2
1
1
B
Removing the red limit stop ring
□
Make sure the cartridge assembly (2) is in the off
position. Remember the position of the red limit
stop ring (1) on the cartridge assembly (2).
Remove the red limit stop ring (1) from the
cartridge assembly (2).
D
12
D
1
2
