Idiomas disponibles
Idiomas disponibles
If this happens, stop cutting and allow the diamond cutting
disc to cool down by running the power tool for a short time at
maximum speed with no load.
If work is noticeably slower and circular sparking is present,
this indicates that the diamond cutting disc has become blunt.
You can resharpen the disc by briefly cutting into abrasive ma-
terial (e.g. lime-sand brick).
Information on structural design
Slots in load-bearing walls are subject to DIN 1053 part 1 or
country-specific regulations. These regulations must be ob-
served under all circumstances. Seek advice from the respons-
ible structural engineer, architect or construction supervisor be-
fore starting work.
Recommendations for optimal handling of the
battery
Protect the battery against moisture and water.
Only store the battery only within a temperature range of -20
to 50 °C. Do not leave the battery in your car in the summer,
for example.
Occasionally clean the ventilation slots on the battery using a
soft brush that is clean and dry.
A significantly reduced operating time after charging indicates
that the battery has deteriorated and must be replaced.
Follow the instructions on correct disposal.
Maintenance and Service
Maintenance and Cleaning
Remove the battery from the power tool before
r
carrying out work on the power tool (e.g. main-
tenance, changing tool, etc.). The battery should
also be removed for transport and storage.
There is risk of injury from unintentionally pressing the on/
off switch.
To ensure safe and efficient operation, always
r
keep the power tool and the ventilation slots
clean.
Store and handle the accessories carefully.
If the power tool should fail despite the care taken in manufac-
turing and testing procedures, repair should be carried out by
Würth MASTERSERVICE staff.
In all correspondence and spare parts orders, please always
include the article number given on the type plate of the
power tool.
The current spare parts list for this power tool can be found on-
line at https://pm.wuerth.com/index.php or requested from
your nearest Würth branch.
24
Warranty
For this Würth power tool, we offer warranty in accordance
with legal/country-specific provisions from the date of pur-
chase (verified by invoice or delivery note). Any ensuing dam-
ages are resolved by means of repair or delivery of replace-
ment parts.
Damage that can be attributed to natural wear, overloading
or improper handling is not covered by the warranty.
Claims can only be accepted if the power tool is sent in an un-
dismantled condition to a Würth branch, your Würth sales rep-
resentative or an after-sales service centre for power tools that
has been authorised by Würth.
Transport
The contained lithium-ion batteries are subject to the Danger-
ous Goods Legislation requirements. The batteries are suitable
for road-transport by the user without further restrictions.
When shipping by third parties (e.g.: by air transport or for-
warding agency), special requirements on packaging and la-
belling must be observed. For preparation of the item being
shipped, consulting an expert for hazardous material is re-
quired.
Dispatch battery packs only when the housing is undamaged.
Tape or mask off open contacts and pack up the battery in
such a manner that it cannot move around in the packaging.
Please also observe the possibility of more detailed national
regulations.
Disposal
Power tools, rechargeable batteries, accessories
and packaging should be sorted for environ-
mental-friendly recycling.
Do not dispose of power tools and batteries/re-
chargeable batteries into household waste!
Only for EU countries:
According to the Directive 2012/19/EU, power tools that are
no longer usable, and according to the Directive 2006/66/
EC, defective or used battery packs/batteries, must be collec-
ted separately and disposed of in an environmentally correct
manner.
Battery packs/batteries:
Li-ion:
Please observe the notes in the section on transport (See
"Transport", Page 24).
