Blackmagic Design 2110 IP Converter 3x3G Manual De Instalación Y Funcionamiento página 6

Using the second Blackmagic 2110 IP Converter 3x3G connect an SDI monitor or other SDI
equipment to the first SDI output on the rear of the unit.
Plugging in Ethernet
Now connect your two converters directly using a Cat 6 Ethernet cable.
The network status icon in the upper left corner of the LCD home screen will indicate '10G'
when a successful connection is made. This will be visible on both units.
Subscribing to a Stream
On the front panel of the second Blackmagic 2110 IP Converter 3x3G you can now select the
stream for your SDI output using the menu. This is known as subscribing to a stream.
To subscribe to a stream:
1 Press the 'menu' button to open the menu and press 'set' to select the 'SDI
outputs' submenu.
2 Rotate the menu dial to 'SDI 1' and press 'set'. The streams from the first converter will
appear in a list which you can select by rotating the menu dial and pressing 'set'.
3 If the output doesn't appear on the front panel display, press the '1' button twice to change
to output mode.
SDI
1 1 MENU
2 SET
3 LOCK
Ethernet
Getting Started 6