Blackmagic Design 2110 IP Converter 3x3G Manual De Instalación Y Funcionamiento página 5

Getting Started
Getting started with Blackmagic 2110 IP Converter 3x3G is as simple as connecting power,
adding your SDI sources and then connecting the two converters directly using a Cat 6
Ethernet cable.
SDI
The illustration shows a point to point connection with a HyperDeck connected to the first IP
converter's SDI input that sends the video to the second IP converter via Ethernet. The second
converter can then output the video to SDI equipment such as a SmartView monitor or an
ATEM switcher.
Plugging in Power
To power your Blackmagic 2110 IP Converter 3x3G, plug a standard IEC cable to the power
input on the rear of the converter. Once powered, the LCD will prompt you to select your
language. Using the menu dial, scroll to the language you wish to use and press the flashing
'set' button. This will take you to the home screen.
Plugging in SDI Sources
Connect the HD source to the first 3G-SDI input on the first unit. Your source could be a camera
or HyperDeck or any other 3G-SDI HD equipment. Once connected, the input will appear on
the front panel LCD.
Ethernet
H/V BLUE 3D 3D H V
INPUT DISP DELAY ONLY ZOOM PEAK LUT 1 LUT 2 MARK MARK
SDI
Getting Started 5