Blackmagic Design 2110 IP Converter 3x3G Manual De Instalación Y Funcionamiento página 19

For example, if the conflicting address is 192.100.40.30 change the last number field to anything
other than 30. If the new number is also being used, keep changing it until you find a unique
number that isn't being used by other equipment.
Allow utility administration
Enabling the 'via USB' setting limits setting changes to only the computer connected via USB.
This removes the risk of anyone on the network making accidental settings changes.
2110 Multicast Output
Each ST 2110 stream output from your Blackmagic 2110 IP Converter 3x3G uses its own
multicast output address. These can be found via the setup utility or by using the LCD menu.
Precision Time Protocol
When connecting Blackmagic 2110 IP Converter 3x3G to a 10G network switch with a PTP
grandmaster, the converter needs to be set to follower mode to prevent a timing conflict.
If two Blackmagic IP converters are connected directly, set one to be the follower by ticking the
checkbox.
Reference Output
To change the reference output for the ref out BNC connector on the rear of the converter,
select the reference from the menu.
Reset
Click 'factory reset' to restore your Blackmagic 2110 IP Converter 3x3G to factory settings. Once
you press 'set', you will be prompted to confirm your selection. To proceed, click 'reset'.
Installing into a Blackmagic Universal Rack Shelf
Your Blackmagic 2110 IP Converter 3x3G shares a compatible form factor with many other
Blackmagic Design units that can be mounted in a rack. The next section of this manual shows
how to install the converter into the Blackmagic Universal Rack Shelf.
Blackmagic Converters Setup 19