cecotec BOLERO COOLMARKET UF 380 INOX D Manual De Instrucciones página 74

ENGLISH
refrigerant load in the freezer must not be less than 8 g/m
- During operation, the freezer releases heat into the environment. Therefore, you should
leave at least 30 mm of free space at the top, more than 100 mm on both sides, and more
than 50 mm at the rear of the freezer.
W (mm) D (mm)
710 770
Fig. 2
Please note
Figure 2 only illustrates the space required for the freezer.
Stable surface
Place the freezer on a solid, flat surface to keep it stable, otherwise vibrations and noises will
occur.
Ensure a ventilation free of obstacles around the freezer.
Waiting time
Once the freezer is installed and clean, do not turn it on immediately, wait at least 1 hour
before connecting it to the power supply.
Switch-on
- Connect the plug into a power socket to switch on the freezer. After one hour, open
the freezer compartment door: if the temperature inside the freezer compartment has
dropped, the cooling system is running normally.
- Once the freezer is operating and the temperature inside has considerably decreased, you
can introduce food.
- If the freezer is installed in a wet place, you must check the earthed cord and the leakage
breaker are working normally. If vibration noises occur due to contact of the freezer with
the wall or if the wall turns black due to air convection around the compressor, remove
the freezer from the wall.
- The installation of the freezer may cause interference in mobile phones, landline phones,
radio receivers, or televisions near the refrigerator, so in this case, keep the freezer as far
away from these objects as possible.
Change of door direction
a. Use a suitable tool to remove the screws from the top hinge cover, remove the top hinge
cover and install the communication cable into the hole at the top of the freezer (Fig. 3).
b. Unscrew the screws on the top right hinge and remove it, then remove the right hinge
cover switch and magnet from the top right-hand side of the door (Fig. 4).
c. Open the cable hole cover from the top right side of the door, place the
communication cable in the hole and then cover it (Fig. 5).
74 BOLERO COOLMARKET UF 380 INOX D
H (mm) A (mm)
1855 1297
.
3
B (mm) C (°)
1407 130±5
E (mm) F (mm)
50 100