Idiomas disponibles
Idiomas disponibles
EN
- only if they have been removed previously, mount the rear casing
and the combustion chamber back on again
- attach the profile (3) with the screws provided to close the front
combustion air inlet.
6.6
CONNECTION TO THE FUME EXHAUST
a
We recommend carefully reading the chapters
mum safety
clearances" and
The appliance is standard-configured with the fume exhaust on the top (Su).
a
To connect the fume exhaust to a stainless steel
pipe, it may be necessary to use a dedicated fitting;
if this is the case, consult the specifications of the
steel pipe manufacturer.
6.7
INSTALLING THE KIT
6.7.1 KIT FOR BASE WITH ADJUSTABLE FEET
To install the kit, proceed as follows:
- remove the combustion chamber entirely – see paragraphs
moving the fume
adapter" and
ber"
- turn the outer casing (1) upside-down and place it on the floor on
the rear side
- fasten the two supports of the base (2) to the plate; make sure that
the brackets of the feet (3) face outwards, insert the bolts from in-
side the casing and screw on the nuts provided with the kit, without
tightening them firmly
16
x2
4
Fig. 14
"Mini-
"Flue gas
channel".
Su
Fig. 15
"Extracting the combustion cham-
- attach the two reinforcements (4) to the supports and screw on the
nuts and bolts provided with the kit, without tightening them firmly
- tighten the feet (3) firmly, turn the assembly that has just been
mounted in the vertical position and firmly tighten all nuts and bolts
- place the insert in the desired position and level it by moving the
adjuster feet.
x2
2
4
6.7.2 FRONT VENTILATION KIT
To install the kit, proceed as follows:
- remove the combustion chamber entirely – see paragraphs
moving the fume
ber"
- remove the two plates (1) from inside and the upper casing (2)
- mount from the inside the new upper casing (3), the upper filler pro-
file (4) and the two new plates (5) already fitted with fans and inlet
3
4
2
"Re-
x2
x4
x4
3
adapter" and
"Extracting the combustion cham-
5
1
CS.STB.IST-1_EN_Rev.1.0_08-23
INSTALLATION
1
Fig. 16
"Re-
Fig. 17
