Idiomas disponibles
Idiomas disponibles
the glass with the following characteristics: the joint has an angle ( ) under 45º and its
distance to the frame (lb) is higher than 5 mm; the robot could become loose and fall. If the
joint in your windows have these characteristics, do not use the robot.
3. OPERATION
Important
The robot must always be connected to the power supply in order to operate.
Connectivity
Fig. 3
1. Plug the power cord to the cable from the power adapter.
2. Plug the connector to the WinDroid and press the trigger.
3. Finally, plug the power cord to the electric circuit.
On/Off
Fig. 4
Hold down the On/Off button to turn the device on or off.
During operation, press the On/Off button to pause or start the cleaning process.
How to charge the battery
Please note
The WinDroid battery has a safety system which, in the event of a power failure, has a back-up
of up to 30 minutes. The approximate back-up time (30 minutes) will depend on the current
charge when the device stops receiving electrical power or on the previous work. Make sure
your battery is completely charged before starting the device (green light).
1. Turn off the switch, plug the power cord, and the orange light will turn on, indicating it is
charging the battery.
2. When it is completely charged, the light will turn green.
Charging time is approximately 2 hours. It can vary depending on the charging conditions (fully
or not) and the product age.
How to assemble the cleaning cloth and ring
Fig. 5
-
Assemble the cleaning cloth onto the ring.
-
Place the ring in the cleaning disc. Make sure it is properly placed to avoid leakages.
ENGLISH
51
