Idiomas disponibles
Idiomas disponibles
ENGLISH
-
Safety rope
-
12 mops
-
1 set of cleaning discs
-
4 cleaning rings
-
Instruction manual
-
Remote control
-
Batteries 2 x AAA
-
Take the product out of the box and remove all packaging materials.
-
Make sure all parts and accessories are present and in good conditions. If there is any
piece missing or not in good condition, immediately contact the Technical Support Service
of Cecotec.
-
Check if the safety rope is broken or the knot is loose.
-
Fasten the safety rope and tie to indoor fixture before operating the device.
-
Make sure the battery is fully charged (green light indicator on).
-
Turn the robot on before putting it onto the glass. Once on the glass, make sure it remains
stuck before letting it go.
-
Remove anything on the glass.
-
Note: Before operating the remote control, remove the insulation spacer at the bottom of
the back side. To remove or change the batteries, just slide the battery cover downwards.
Warnings
-
It is recommended to supervise the robot's operating during its first use in order to ensure
it operates properly on the surface you wish to clean.
-
The device should not be unattended while it is connected to a power supply.
-
Always use the safety rope. Ensure its proper positioning and state.
If you wish to clean a surface with specific features and you are not sure if the robot will work
properly, increase the precautions taken and supervise its operation.
Warning
Remember that the safety rope must be always used.
-
Conga WinDroid 880 has been designed to clean every type of window, store window, or
standard, flat, vertical surfaces.
-
For safety reasons, it is recommended not to use the product under the following
circumstances:
-
Do not use the robot in windows or glass without frames.
-
Do not use the robot on curved windows, both concave and convex.
-
Do not use the robot in windows thinner than 3 mm.
-
Do not use the robot in windows with a joint (silicone or rubber) between the frame and
50
