cecotec HIDROBOOST 3200 INDUCTION PRO Manual De Instrucciones página 62

ENGLISH
There is not enough pressure.
The pressure washer does
not turn on.
Pressure fluctuates.
The motor stops suddenly.
6. TECHNICAL SPECIFICATIONS
Product reference: 05405
Product: HidroBoost 3200 Induction Pro
Power and voltage: 3200 W, 220-230 V~ 50 Hz
Pressure: 15 MPa – 150 bar
Maximum pressure: 22.5 MPa – 225 bar
Flow: 7.5 l/min (450 l/h).
Maximum flow: 9 l/min - 540 l/h.
H I D R O B O O S T 3200 INDUCTION PROCLEAN
62
The inlet water filter is
clogged.
Air is entering from the hose
connections to the pump.
The nozzle or discharge valve
is worn or not the correct
size.
The unit is pressurised.
The plug is not properly
connected or the socket is
defective.
The extension cord is too long
or short.
The supply voltage is too low.
The thermal safety switch
has tripped.
The pump is sucking in air.
The nozzle is clogged.
The valves are dirty or worn.
Hydraulic seals are worn.
The extension cord is too long
or short.
The thermal safety
switch has tripped due to
overheating.
Clean the inlet water filter.
Check that the connections
and the locking ring are tight.
Contact the Technical Support
Service of Cecotec.
Press the gun trigger.
Check the plug, the mains and
the fuses.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance.
Switch off the device and
allow it to cool down.
Check that hoses and
connections are tight.
Clean it with the cleaning kit.
Contact Cecotec
Technical Support Service.
Contact Cecotec
Technical Support Service.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of
the appliance.
ORIGINAL MANUAL TRANSLATION