cecotec HIDROBOOST 3200 INDUCTION PRO Manual De Instrucciones página 61

- Do not store the pressure washer outdoors or where it can freeze. The pump could be
severely damaged.
- The water inlet anti-impurities filter must be regularly checked to prevent blockages in the
water supply to the pump
Fig. 6
Nozzle cleaning
- A clogged or partially clogged nozzle can significantly reduce water output and cause
intermittent jetting. To clean the nozzle:
- Turn off and unplug the unit.
- Disconnect the water supply. Press the trigger 2 or 3 times to release the pressure trapped
in the hose.
- Disassemble the wand.
- Use the cleaning kit provided or an unfolded paper clip, and insert it in the nozzle hole.
Move it inwards and outwards until all dust and dirt is removed.
- Pour water through the nozzle hole into the nozzle in order to clean the dirt remains. To do
this, point an operating garden hose at the nozzle for 30-60 seconds.
Fig. 7
5. TROUBLESHOOTING
Problem
Soap is not absorbed.
Smoke comes out of the
appliance.
Cause
The high-pressure hose or
the hose are too long.
The pump injector is blocked.
The soap accessory is
blocked.
Overheating, overloading, or
motor failure.
H I D R O B O O S T 3200 INDUCTION PROCLEAN
ENGLISH
Solution
Remove the high-pressure
hose or use a shorter one
(shorter than 7 m).
Contact the Technical Support
Service of Cecotec.
Clean the accessory with
lukewarm water.
Replace the accessory.
Turn off the device
immediately and contact the
Technical Support Service of
Cecotec.
61