ENGLISH
-
Connect the metallic wand and the nozzle by pressing the connector.
-
Check that the water filter is clean and it is not clogged.
-
Connect the water hose.
-
Make sure the hoses are not tangled.
-
Turn on the water and check if there is any leak.
-
Press the trigger to depressurise, so trapped air will escape through the pump and the
high-pressure hose. Lock the trigger.
-
Connect the device and turn it on.
-
Unlock the trigger and use the pressure washer.
Warning
It is very important to let air out of the gun before using the pressure washer. Press the trigger
to let all the trapped air out of the unit and of the high-pressure hose. Hold down the trigger
until a continuous water jet comes out of the nozzle. This process may take 2 minutes.
3. OPERATION
This portable pressure washer is a highly specialised, functional machine, with an exceptionally
reliable security system, which can be used to clean cars, bicycles, and other outdoor surfaces
such as terraces, patios, or gardens.
Warning
Beware of the setback caused by the force of the water when activating the machine.
Warning
Pay special attention when cleaning surfaces susceptible to damage, such as vehicle bodywork
or rims, lacquered surfaces, wood, paintwork, etc.
Automatic on and off
The motor of this pressure washer does not run continuously, it only operates when you press
the trigger. Once the initial procedures in this manual have been carried out, turn the pressure
washer on and press the trigger to activate the pressure washer.
Turning off
1.
Turn off the motor (place the switch in the off position).
2.
Disconnect the device from the power supply.
3.
Turn off the water supply.
4.
Press the gun trigger to depressurise the system.
5.
Remove the water inlet hose from the pressure washer.
6.
Use a clean and damp cloth to clean the device surface.
7.
Place the trigger lock.
H I D R O B O O S T 3200 INDUCTION PROCLEAN
58
ORIGINAL MANUAL TRANSLATION