Idiomas disponibles
Idiomas disponibles
ENGLISH
Direct exposure to sunlight or great light contrasts may affect the correct operation of the
-
sensors. If this happens, the robot will stop operating, move it to a new location for it to
start operating again.
3. INSTALLATION
1.
Place the charging base against the wall and leave a minimum free space of 2 metres
to the front and 1 metre to each side. Fig. 15
2. Connect the charging base to a power socket. Wind and store the remaining cable in
the lower part of the charging base to prevent accidents. Fig. 16
3. Install both side brushes in their corresponding slots, located on the robot lower part.
Press until they click to make sure they are properly fixed. Fig. 17
4. Press the power switch located on the side of the robot. Make sure the power switch
is in the on position (I). Fig. 18
5. Place the robot on the charging base and make sure the charging terminals on the
robot match those of the charging base. Once the robot is properly placed, it will beep
once and the light indicator will light up. If the light is oscillating orange, it means the
battery is not completely charged. To ensure the maximum cleaning time, wait until
the light turns into steady blue, as this will indicate the battery is fully charged and
the robot is ready to clean. Fig. 19
4. OPERATION
Starting the cleaning. Fig.
1.
Hold down the Start/Pause button on the robot to turn it on.
2. Press the Start/Pause button on the robot vacuum cleaner, on the remote control or
on the app to start cleaning.
Note
If the robot runs out of battery while cleaning, it will automatically return to the charging
-
base. Once the battery is fully charged, the robot can start a new cleaning cycle.
If there is no good access to the charging base, the robot will not be able to return to it. If
-
this happens, place it manually on the charging base.
Pausing the cleaning. Fig.
Press the Start/Pause button on the robot vacuum cleaner, on the remote control or on the
-
app to pause the cleaning process.
Press the Start/Pause button on the robot vacuum cleaner, on the remote control or on the
-
app to resume the cleaning process.
42
20
20
