Idiomas disponibles
Idiomas disponibles
3.
Use a 6 mm socket and wrench or 6 mm nut driver to
remove the brass orifice from the end of gas valve.
Replace with the Natural gas orifice.
IMPORTANT: Check that the orifice is properly installed
inside of the burner opening.
4.
Reinsert the burner and reattach using the cotter pin
previously removed. Repeat the procedure for each main
burner.
5.
Position the igniters so they are 3.18 mm / 1/8 in. away
from each burner.
6.
Open the manual shutoff valve in the gas supply. The
valve is open when the handle is parallel to the gas pipe.
7.
Test all connections using an approved noncorrosive
leak- detection solution. Bubbles will show a leak.
Correct any leak found.
8.
For normal operating sequence of the ignition system,
see "Lighting Instructions" on page 9.
Adjust High/Low Flame Setting Screw
When converting from LP to Natural gas, you will need to
adjust the high flame setting screw for ideal burner flame
height.
The flames of the grill burners and side burners (on some
models) should be blue and stable with no excessive noise or
lifting (LP gas flames will have a slightly yellow tip). A yellow
flame indicates not enough air. If flame is noisy or lifts away
from the burner, there is too much air. Some yellow tips on
flames when the burner is set to HIGH setting are acceptable
as long as no carbon or soot deposits appear. The flames
should be approximately
All manuals and user guides at all-guides.com
2.54 cm / 1 in
high.
2.54 cm / 1 in
1.
Remove each control knob for the main burners.
2.
Use a flat-blade screwdriver to turn the high flame set
screw clockwise approximate 90º.
3.
Check that burner operates at the new high flame setting.
It may be necessary to adjust the screw setting slightly
more to get the ideal burner flame height.
4.
Replace the control knob and turn off the burner.
5.
Repeat steps 2 through 4 for each burner if needed.
6.
Replace the flame tamers and grates after the burners
have been cooled.
Record Conversion
The LP appliance nameplate is located inside the grill cabinet
on the left-hand side. Once converted, place the NG
appliance nameplate as close as possible to the current LP
appliance nameplate without covering it.
In the last page of the Use and Care Guide, write "Converted
to Natural Gas". Also record the conversion date and the
technician/company that performed the conversion.
13
