Installing The Batteries; Connecting To The Power Supply; Basic Operation; Fm Radio Operation - Lenco KCR-11 Manual De Usuario

INSTALLING THE BATTERIES FOR CLOCK/FM PRESET CHANNEL/TIMER BACKUP
The clock/FM preset channel/timer (if set) will be maintained during a power failure by installing 2 x AAA/LR03 batteries (not
supplied). Once the power is restored, check the clock to make sure it is accurace and set it again if necessary.

INSTALLING THE BATTERIES

1. Open the battery compartment at the bottom of the unit by pressing on the catch and removing the cover.
2. Insert 2 x AAA/LR03 batteries (not supplied), preferably alkaline batteries, into the battery compartment following the polarity as
shown on the diagram inside the compartment.
3. Replace the battery compartment cover.

CONNECTING TO THE POWER SUPPLY

Plug the AC power cable into the AC wall socket.

BASIC OPERATION

Press the STANDBY button to turn on the unit. To turn off, press the STANDBY
Volume Control
Press the VOLUME +/- buttons to change the volume.
Adjusting the Antenna
e at
The antenna wir the rear panel of the unit should be fully extended to ensure a good FM reception. Alter the antenna position
for the best reception.

FM RADIO OPERATION

Auto Scan
1. Turn on the unit in FM mode.
2. Press and hold the SCAN button to start auto-scanning and saving the available channels (Max. 20 stations can be stored.)
Manual Scan
1. Press the or button repeatedly to tune to a different frequency.
2. Press and hold the
Storing FM Presets
You can save up to 20 FM presets.
1. Tune to the station you wish to store.
2. Press and hold the MEM. button. Flashing preset channel number is displayed.
3. Press the or button to a preset number that you want to store. Then press the MEM. button to save.
Recall Stored FM Presets
Press the MEM. button to tune to different preset channel.
To directly recall the preset channel by using the numeric buttons, press the numeric buttons [1], [2], ..., [5].
For example when the button [3] is pressed, the display shows "P03" and wait for a while it will tune to the preset 3.
Or when press and hold the button [3/(8)] until the display shows "P08" and wait for a while, it will tune to the preset 8.
Or when press the button [1] and followed by pressing the button [2], the display will show "P12" and after a while it will tune to the
preset 12.
Or when press the button [1] and followed by press and hold the button [3/(8)], the display will show "P18" and after a while it will
tune to the preset 18.
Stereo/Force Mono Selection
When receiving a Stereo FM radio channel, press the ST/MONO button will switch between stereo audio and force mono audio.
When it is in FM Stereo, the FM-ST LED will be turned on.
Note:
wire a
The ntenna at the rear panel of the unit should be fully extended to ensure a good FM reception. Alter the antenna
-
position for the best reception.
or button to automatically search to the next available channel.
button again.
7