Connecting To The Power Supply; Fm Radio Operation - Lenco SCD-301 Manual De Usuario

CONNECTING TO THE POWER SUPPLY

1. Connect the end of the detachable power cord to the unit rear panel ~ AC IN jack and the other end to the AC outlet.
2. Press the STANDBY
BATTERY POWERED USAGE
For DC operation, firstly remove the AC plug from the AC outlet and disconnect the AC cord from the ~ AC IN jack. Then
insert 6pcs size C (UM-2) batteries (NOT supplied) into the battery compartment.
Note:
Since the unit draws a little power from the batteries standby mode, remove the batteries if the unit is not going to be
-
used for a long time.
BASIC OPERATION
Press the STANDBY
FM/CD/USB/AUX IN
Press the FUNC. button to select between different sources.
Volume Control
Press the VOLUME +/- buttons to change the volume.
Adjusting the Antenna
The antenna at the rear panel of the unit should be fully extended to ensure a good FM reception. Alter the antenna
position for the best reception.

FM RADIO OPERATION

Auto Scan
1. Turn on the unit in FM mode.
2. Press and hold the
Manual Scan
1. Press the PREVIOUS
2. Alternatively press and hold the PREVIOUS
station.
Storing FM Presets
You can save up to 30 FM presets.
1. Tune to the station you wish to store.
2. Press and hold the PRESET button. Flashing preset station number is displayed.
3. Press the PREVIOUS
button to save.
Recall FM Presets
Press the PRESET button to tune to the next FM preset station.
Stereo/Force Mono Selection
When receiving a stereo broadcast FM station, press the FM ST/MO button will switch between stereo audio and force
mono audio.
CD/USB OPERATION
Loading and Playing CD Disc
Open the CD door. Install a disc with the CD label side facing up. Close the CD door. Press the FUNC. button to CD
mode. After reading, the total number of tracks will be shown on the display and it will automatically start to play.
Reading and Playing USB Device
Insert a USB device into the USB input jack. Press the FUNC. button to USB mode. After reading the total number of
tracks will be shown on the display. It will automatically start to play.
Play/Pause Control
To pause playback press the PLAY/PAUSE
Stop Control
To stop playback press the STOP
Skip Track
During playback press the PREVIOUS
button to turn on the unit.
button to turn on the unit. To turn off, press the STANDBY
button to start auto-scanning and saving the available stations (max. 30 storage).
or NEXT button repeatedly to tune to a different frequency.
or NEXT button to a preset number that you want to store. Then press the PRESET
button. Press the button again to resume playback.
button.
or NEXT
or NEXT button to automatically search to the next available
button to skip to the previous or next track.
7
button again.