Idiomas disponibles
Idiomas disponibles
IMPORTANT
NOTE TO INSTALLER
Please read the following instructions carefully before installing your Washer.
These instructions should be retained for future reference.
We recommend you hire a professional for installation of this washer.
STEP
1
Selecting
a Location
Before you install your washer, make sure the location:
•
Has a hard, level surface without carpeting or flooring that may obstruct ventilation.
•
Has no dust, oil and detergent etc.
•
Is away from direct sunlight
•
Has adequate ventilation
,,
Will not freeze (below 32°F or 0°C)
•
Is away from heat sources such as oil or gas
•
Has enough slack for the power cord.
•
Doesn't have any carpeting that will obstruct ventilation openings.
STEP 2
Removing
the Shipping
Bolts
Before using your Washer, you must remove the four shipping
bolts from the back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with the
spacer through the hole in the rear wall of your washer.
Repeat for each bolt.
3. Fill the holes with the supplied Bolt Hole Covers (See page 12).
4. Keep the shipping bolts and spacers for future use.
instNing
your washer 15
WF520AB-02838A
EN.indd
15
2010-03-24
_;2Xt_.& 4:30:26
