Idiomas disponibles
Idiomas disponibles
Water
To correctly fill your Washer in the proper amount of time, water pressure of 20-116psi (137-
800kPa) is required.
Water pressure less than 20 psi may cause water valve failure, or may not allow the water valve
to shut off completely. Or, it may extend the fill time beyond what your Washer controls allow,
resulting in your Washer turning off. A time limit is built into the controls in the event of an internal
hose becoming loose and flooding your home.
The water faucets must be within 4 feet/122cm of the back of your Washer for the inlet hoses
provided with your Washer.
[_
ccessory inlet hoses are available in various lengths up to 10 feet/305cm for faucets that
are further away from the back of your Washer.
To avoid the possibility of water damage:
•
Have water faucets easily accessible
Turn off faucets when the washer is not in use.
Periodically check that there is no leakage from the water inlet hose fittings.
Z_
CHECK ALL CONNECTIONS AT THE WATER VALVE AND FAUCET FOR LEAKS.
WARNING
Drain facility
The recommended height of the standpipe is 18 in/46 cm. The drain hose must be routed
through the drain hose clip to the standpipe. The standpipe must be large enough to accept the
outside diameter of the drain hose. The drain hose is attached at the factory.
Flooring
For best performance, your Washer must be installed on a solidly constructed floor. Wood floors
may need to be reinforced to minimize vibration and/or unbalanced load situations. Carpeting
and soft tile surfaces are contributing factors in vibration may cause your washer to move slightly
during the spin cycle.
Never install your washer on a platform or weakly supported structure.
Location
considerations
Do not install your washer in areas where water may freeze, since your washer will always
maintain some water in its water valve, pump, and hose areas. This can cause damage to the
belts, the pump, hoses and other components.
Alcove or closet installation
MINIMUM
CLEARANCES
FOR CLOSET AND ALCOVE
INSTALLATIONS:
Sides - 1 in / 25 mm
Top - 17 in / 432 mm
Rear - 4 in / 102 mm
Closet Front - 2 in / 51 mm
If the washer and dryer are installed together, the closet front must have at least a 72 in2(465
cm *) unobstructed air opening. Your washer alone does not require a specific air opening.
14 instNing
your washer
WF520AB-02838A
EN.indd
14
2010-03-24
&2_t_._4:30:25
