Idiomas disponibles
Idiomas disponibles
PRODUCT OVERVIEW
The cordless compressor is a device that allows for infl ating tyres or other objects, e.g., balls or mattresses with compressed air.
It is also possible to supply some pneumatic tools from the compressor, e.g. a blow gun. The battery power supply increases the
mobility of the product. The correct, reliable, and safe operation of the device depends on its proper use, therefore:
Read the entire instructions manual before the fi rst use of the device, and keep it for future reference.
The supplier shall not be held liable for any damage resulting from failure to observe the safety regulations and recommendations
specifi ed in this manual.
PRODUCT EQUIPMENT
In the case of the YT-23241 article, the product is equipped with two batteries and a charger. The YT-23242 article is not equipped
with batteries and a charger. Both articles are equipped with accessories to facilitate infl ating of various products. A fl exible hose
is not included.
TECHNICAL DATA
Parameter
Catalogue No.
Rated voltage
Rated power
Rated pressure
Infl ating capacity
Noise level
- sound pressure L
± K
pA
- power L
± K
wA
Weight
Protection rating
Battery type
Battery capacity
Charger*
Input voltage
Mains frequency
Rated power
Output voltage
Output current
Charging time**
* only for models equipped with a battery and charger
** the specifi ed charging time applies only to the battery with the capacity listed in the table
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the initial exposure assessment.
Caution! Safety measures to protect the operator, which are based on an assessment of emission exposure under actual con-
ditions of use (including all parts of the work cycle, such as the time when the tool is turned off or idle and the activation time),
must be specifi ed.
SAFETY INSTRUCTIONS
Learn how to use the tool. Do not start working or charging before reading the instructions manual. Following the guidelines con-
tained in the instructions manual reduces the risk of injury, electric shock or fi re.
The device is not intended for use in potentially explosive atmospheres and highly humid and dusty environments. The tempera-
ture at the workplace should be within the range of +5
should not operate near places where water is sprayed.
Place the device only on a hard, even and fl at surface.
Make sure that the ventilation openings in the device housing are not obstructed during and after the operation.
During operation, some elements of the housing may become hot – touching them may cause burns. To carry the device grasp it
only by the handle. The device must be turned off before carrying. The power switch must be in the off position and the batteries
O R I G I N A L
10
EN
Unit
[VDC]
[W]
[MPa / bar / PSI]
[l/min]
[dB(A)]
[dB(A)]
[kg]
[Ah]
[VAC]
[Hz]
[W]
[V DC]
[A]
[h]
C to +40
C, and the relative humidity should not exceed 80%. The device
O
O
I N S T R U C T I O N S
Value
YT-23241, YT-23242
36
800
0.8/8/116
98
80.0 ± 3.0
90.7 ± 3.0
11
IPX0
Li-Ion
3
220 - 240
50 / 60
60
21 DC
2.4
1.5
