Idiomas disponibles
Idiomas disponibles
b
ncj
nform
on
INFORMATION
CODES
Information codes may be displayed to help you better understand what is occurring with your Washer.
I
Unbalanced load prevented your
OC
Washer from spinning.
Door is open when Washer is
running.
Your Washer failed to lock the
door.
Water temperature control
oroblem.
.....................
(Heater Control problem)
Your Washer has tried to fill but
has not reached the proper water
level.
The door will not
unlock.
LU
iii
i
i
/-if
¸
Jammed Key.
i-C
I tm
Motor speed sensor problem.
OC
Motor not running properly.
Your washer is not draining.
It can also mean that the unit
senses a small clog while draining.
Your Washer has tried to fill but
was unsuccessful.
The hot/cold water hose
connection is not correct.
Electric service was lost when
Washer was running.
A fault is detected in the water
level sensor.
Redistribute the load, press the Start/Pause
Button.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Call for service.
Call for service.
Make sure the door is firmly closed.
Push the Power button to turn off your Washer,
then turn it on again. If the code reappears, call
for service.
Restart the cycle pressing the Start/Pause
Button. If the code reappears, call for service.
Before calling for service, check the following.
1) Turn off the unit and turn it on again.
2) Select only the Spin Cycle.
3) Press the Start/Pause to drain the water.
Clean the debris filter.
If it still does not drain, call for service.
Make sure the water faucets are open all the
way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
Please connect the hot/cold water hose
connection correctly.
Restart the cycle by pressing the Start/Pause
Button.
Call for service
Call for service
Restart the cycle.
If the code reappears, call for service.
32 troubleshooting
and informaton
codes
WF210AN-02832A
EN.indd
32
2010-02-09
o_,,,f
1:15:17
