Bosch HMV3022U Manual De Instalación página 13

Ocultar thumbs Ver también para HMV3022U:
Idiomas disponibles

Idiomas disponibles

5. Draw the 2 vertical plumb lines down from the marks
made in Step 2 to complete the 12"x 4" (304 x 102
mm) rectangle. This is the venting cutout area.
The 12"x 4" (305 x 102 mm) cutout area must align
with the wall damper vent (where the damper
assembly will be installed) on the back of the
microwave oven.
I li ' m,
1 ::::
I
6"
6"
E
i
Note: Cutout must be free of any obstruction
(e.g.
wiring, pipes, etc.) so that the vent fits properly, and
the damper hinge opens fully and swings freely.
6. Using a saber or keyhole saw, cut out this area
through the rear wall.
Mounting
the microwave
oven
Notes
o If the bottom of the upper cabinet is recessed or has
front overhang, you will need to prepare 2"x 2" (51
mm x 51 mm - depth equivalent to cabinet recess or
overhang) filler blocks to provide additional support for
the bolts:
o mark the center of each filler block and drill a 3\8"
(9,5 mm) diameter hole
o align filler blocks over the three openings on top of
the microwave oven and attach with masking tape
o Use at least two people to install the microwave oven.
Do not grip or use handle during the installation.
2. Rotate the front of the oven up against cabinet bottom.
3. Insert a self-aligning screw (item A) through top center
cabinet hole. Temporarily
secure the oven by turning
the screw at least two full turns after the threads have
engaged.
4. Insert the two remaining
self-aligning screws through
outer top cabinet holes. Turn two full turns on each
screw.
o When mounting the microwave oven, thread power
cord through hole in bottom of top cabinet. Keep the
cord tight and do not pinch it, especially when
mounting flush to bottom of cabinet. Do not pull the
cord to lift the oven.
1. Lift the microwave,
tilt it forward, and hook slots at
back bottom edge onto four lower tabs of the
mounting plate.
5. Tighten center screw completely.
6. Tighten the outer two screws completely to the top of
the microwave oven.
Note: While tightening
screws, hold the microwave
oven in place against the wall and the top cabinet.
13
loading

Este manual también es adecuado para:

Hmv3052uHmv3062u300 serie