Seat-To-Floor Height; Changing Seat-To-Flooor Height; Mounting Position - Sunrise Medical Breezy EC Serie Manual De Instrucciones

26
SEAT-TO-FLOOR HEIGHT (Dual axle models only)
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely – otherwise injury or damage may result.
A. CHANGING SEAT-TO-FLOOR HEIGHT (FIGURES 1 & 2)
When changing the seat-to-floor height, the height of the anti-tippers must be adjusted
as well.
NOTE–
The Manufacturer recommends that the following procedure be performed by an authorized
dealer or qualified technician.
1. Remove the rear wheels from the wheelchair. Refer to REMOVING/INSTALLING
THE REAR WHEELS in the "REAR WHEELS" section of this manual.
2. Remove the front casters from the wheelchair. Refer to INSTALLING/REPLACING
SIX OR EIGHT-INCH FRONT CASTERS AND FORKS in the "FRONT CASTERS"
section of this manual.
3. Refer to the chart of front caster/fork and rear wheel sizes, to determine mounting
positions for obtainable seat-to-floor heights.
4. Reinstall the front casters onto the wheelchair. Refer to Refer to
INSTALLING/REPLACING SIX OR EIGHT-INCH FRONT CASTERS AND FORKS in
the "FRONT CASTERS" section of this manual.
5. Reinstall the rear wheels onto the wheelchair. Refer to REMOVING/INSTALLING
THE REAR WHEELS in the "REAR WHEELS" section of this manual.
6. Adjust Anti-tippers according to NEW seat-to-floor height. Refer to ANTI-TIPPERS in
the "ANTI-TIPPERS/WHEEL LOCKS" section of this manual.
SEAT-TO-FLOOR
HEIGHT

MOUNTING POSITION

(IN INCHES)
3
17 /
4
3
19 / 4
MK-100199 RevA
E n g l i s h
WARNING
WARNING
FRONT CASTER REAR
WHEEL
(Fig. 2)
TOP 24 inch
BOTTOM 24 inch
REAR WHEEL
MOUNTING POSITION
SIZE (Fig. 1)
TOP
BOTTOM
S e a t - To - F l o o r H e i g h t
Top
Bottom
Top
Middle
Bottom
1
2