Makita UR014G Manual De Instrucciones página 15

Installing the cutting tool
CAUTION:
Always use the supplied wrenches
to remove or to install the cutting tool.
CAUTION:
Be sure to remove the hex wrench
inserted into the tool head after installing the
cutting tool.
NOTE: The type of the cutting tool(s) supplied as
the standard accessory varies depending on the
countries. The cutting tool is not included in some
countries.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.
Nylon cutting head
NOTICE:
Be sure to use genuine Makita nylon
cutting head.
1. Insert the hex wrench through the hole in the gear
case to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted. Remove the nut by turning it
clockwise with the box wrench.
1
Fig.15
► 1. Nut 2. Hex wrench
2. Remove the spool holder by pressing the claws.
Fig.16
► 1. Spool holder 2. Claw
3. Remove the spool from the spool holder by hold-
ing the nylon cord with your fingers and thumb, and
then hook both sides of the nylon cord to the notches of
the spool.
1
2
Fig.17
► 1. Spool 2. Spool holder 3. Notch
4.
Insert the hex wrench through the hole in the gear
case to lock the spindle. Attach the spool holder to the
2
spindle, and then tighten the nut by turning it counter-
clockwise with the box wrench.
1
2
Fig.18
► 1. Nut 2. Spool holder 3. Hex wrench
NOTE: The recommended tightening torque is 20 to
30 N•m.
15 ENGLISH
1
2
3
3