Important - GE Zoneline 2800 Manual Del Propietario Y Instrucciones De Instalación

www.GEAppliances.com
Door Sensor (Obtained locally)
_]/en connected, tile door sensor will detect
when tile door in tile i'OOill w;is opened or
closed. This teature nmst be used in
coqiunction
with tile motion sensor:
Tile door
and
i/lotion sensoi3 work together
to automaticall_ set back tile room temperature.
%_ le_ I_ _1 oo i = _ _ _ _ o
L_ DoorSensor
External Fan (Obtainedlocally)
_]/en (onnected, an auxiliary or external tim
can be controlled with tile indoor
tim
motor
on the Zoneline. Com_ections provide 24 V AC
to energize
a remote relay, turning
on tile
external tim.
e-, le,=; I_ _1 _ I = _ _ = "- _ °
o g
I__1
]_ ExternalFan
Central Desk Control
X_l/en connected, tile trait can be turned ON
or OFF with a switch located at tile Central
Control Panel. A separate wire pair nlust be
rtm fl'om
each separate controlling switch to
each individual Zoneline.
% leo ,_ I_ _1 o_ I = _ _, = " _ °
g g
[__J
[Central DeskControl
Remote Thermostat
X_q/en connected, tile refit _fill be controlled
bv a i'elllote thermostat.
NOT£'The number 4 dip switch must be in tile
enabled (UP) position to activate tile remote
themlostat, (See the installation instructions
supplied with tile remote themlostat).
IMPORTANT:
Tile Zoneline them/ostat connections
provide 24 V AC only.
If using a digital/electronic wall themlostat,
you must set it to tile 24 V AC setting.
See tile Installation Instructions for tile
wall them/ostat.
• N leo la _1 g I a _ _=
Red- 24 V AConly
Green- Low SpeedFan --
Green- HighSpeed Fan --
Clack- Solenoid
Yellow- Compressor
White - Heater
Common- Ground
A CAUTION:
Damage to a wall themlostat or m tile
Zoneline electronics can result fl'om improper
com_ecfions. Special care nlust be used in
com_ecting the wires. No line voltage
connections should be made to anv circuit.
Isolate all wires in building ti'om line voltage.