Bralo HT-30 Manual De Instrucciones página 18

BRALO
16. PURGING OR PRIMING MANNER 2
1) Have an oil pan to collect excess oil.
2) Switch on the air supply.
3) Press the trigger and at the same time, slightly
loosen the TRACTION bleed screw (A) to release
the air bubbles keeping the trigger pressed, when
no more air comes out, tighten the screw A.
4) Repeat this procedure several times, until oil
comes out without air bubbles.
17. ASSISTANCE
To keep the tool in good condition, it is
recommended to service the tool and replace
worn parts on a regular basis.
require these services or spare parts, please
contact us directly:
BRALO, S.A. Milanos, 12. Pol. Industrial. La
Estación 28320 Pinto (Madrid) SPAIN
Telephone: +34 91 692 8285
www.bralo.com
Should you
TRACTION BLEED
SCREW (A)
TRACTION BLEED
SCREW (A)
AIR REGULATION
SUCTION BUTTON
ON/OFF
EN
18. GUARANTEE
The warranty is valid for 12 months from the
invoice purchase date.
The guarantee only covers defects in the parts or
their assembly.
Damage to the tool caused by the following
cases is not covered by the warranty:
- Transport.
- Operator usage errors.
- Errors in maintenance work.
- Breakages or failures that are not attributed to
manufacturing defects.
- Normal wear and tear on consumable parts.
The warranty is invalid if tool components
are replaced without authorisation or if worn
parts other than those recommended by the
manufacturer are replaced, which could cause
damage to the tool.
BRALO assumes responsibility for manufacturing
defects, but is not liable if the operator does not
follow the instructions given in this manual.
The tool is built according to the European
Directive in force when the riveting tool is
marketed.
18