Idiomas disponibles
Idiomas disponibles
Attach link bracket extrusion end
plate to link bracket extrusion with
two countersunk head tapping
screws Ø 4.8x22. Set fence square
to sawblade and slide link bracket
extrusion as required to set to ZERO
position. Now tighten the two car-
riage bolts fully, holding the link
bracket extrusion to the table.
-
Set true zero position by
adjusting the setting screw as
required.
Bolt leg to leg bracket using 2 each
carriage bolt M 8x45
washer Ø 8.4 mm
starknob M 8
To accommodate the different ma-
chine heights the leg bracket has
several oblong holes.
Fit mounting screws into the appro-
priate holes.
Use 4 each
carriage bolt M 8x20
washer Ø 8.4 mm
hexagon nut M 8
5
Scale Reading
Slide flipstop onto fence extrusion and set to 200 mm. Adjust position of
extrusion until distance between flipstop and cutting edge of sawblade is
exactly 200 mm. Set stop plate (pos. 349) against link bracket angle bar
(pos. 332) as reference point.
Set fence to 45° position and repeat setting. Set outer stop plate as 45°
reference point.
Slide the prepared legs into the
grooves of the roller carriage extru-
sion, one at either end. Tighten the
mounting bolts.
With the fence not extented the distance to the blade is read directly from
the flipstop. When the fence extension is used the flipstop must be set
to the end position on the fence. The distance between the flipstop and
the blade is then indicated by the reading mark 'A' .
11
Set legs on floor and tighten star-
knobs.
