Idiomas disponibles
Idiomas disponibles
◾
A cold chain is correctly tensioned
when there is no slack on the
underside of the guide bar and the
chain is snug, but it can be turned
by hand without binding. The chain
must be re-tensioned whenever the
flats on the drive links do not sit in
the bar groove.
◾
During normal saw operation,
the temperature of the chain
will increase. The drive links of a correctly tensioned warm chain will hang
approximately 0.050 in. (1.3 mm) out of the bar groove (Fig. 12b).
NOTICE:
New chains tend to stretch. Check chain tension frequently and adjust
tension as required.
NOTICE:
A chain tensioned while it is warm may be too tight upon cooling. Check the
cold tension before next use.
FILLING OIL TANK WITH BAR AND CHAIN LUBRICANT
WARNING:
injury, always remove the battery pack from the chain saw before filling the tank with
oil.
WARNING:
Oil may spill and cause a fire.
NOTICE:
The chain saw is not filled with oil at the time of purchase. It is essential
to fill the tank with chain oil before use. Operating the chain saw without chain oil or
when the oil level is below the "MIN" (minimum) mark will result in damage to the
chain saw. Chain life and cutting capacity depend on optimum lubrication. The chain is
automatically lubricated with chain oil during operation, if there is sufficient oil in the oil
tank.
1. Remove the battery pack from the chain saw.
2. Clean the oil-tank cap and the area around it to ensure that no dirt falls into the
oil tank.
56-VOLT CORDLESS COMMERCIAL 20" CHAIN SAW — CSX5000/CSX5000-FC
To prevent accidental starting that could cause serious personal
Do not smoke or bring any fire or flame near the oil or the chain saw.
12b
Approximately 0.050" (1.3 mm)
27
