Idiomas disponibles
Idiomas disponibles
APPLICATIONS
You may use this inflator for the purpose listed below:
„ Inflating items such as small tires, sports balls, bicycle
tires and to bring vehicle tires up to recommended
inflation levels.
NOTE: The inflator is not designed for commercial applica-
tions.
WARNING:
Battery tools are always in operating condition. Always
remove battery pack from your tool when you are assem-
bling parts, making adjustments, cleaning, or when not
in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 9.
To install:
„ Unscrew and remove the battery cap.
„ Insert the battery pack into the product as shown.
„ Place the cap over the battery pack and push down until
the cap meets the threads at the end of the tool.
„ Screw the cap on securely.
NOTE: Do not attempt to use this product if the battery
cap is not securely closed.
To remove:
„ Unscrew and remove the battery cap.
„ Remove the battery pack from the tool.
AIR HOSE AND ACCESSORY STORAGE
See Figures 2 - 3, page 9.
When the inflator is not in use, press the hose into the stor-
age area on bottom of the tool.
When not in use, adaptors and needles provided with the
inflator can be placed in the storage area on the base of
the tool.
DIGITAL GAUGE
See Figure 4, page 10.
The digital gauge on the inflator serves as a pressure gauge
and monitors the amount of pressure being applied to the
item being inflated.
To turn the digital gauge on, install the battery pack and
press the power button.
NOTE: The LED light illuminates with the digital gauge.
NOTE: The digital gauge and LED light will automatically
shut off when not in use for 30 seconds.
OPERATION
USING THE INFLATOR
See Figures 5 - 8, page 10.
The inflator can be used in different modes as explained in
the Accessories section that follows. Follow these steps
for basic use with the hose and chuck clamp.
„ Install the battery pack.
„ Remove the hose from the storage area.
„ Align the hose in the pump outlet and rotate clockwise
until secure.
NOTE: Do not overtighten.
„ Position air chuck clamp in the unlock position
perpendicular to the air hose.
„ Place the air chuck on the valve stem.
„ Push the air chuck down so that the threaded section of
the valve stem is inside the air chuck.
„ Clamp the end of the air chuck down onto the valve
stem by pressing air chuck clamp down until it stops or
is parallel with the air hose.
WARNING:
Improperly attached hoses or accessories can become
detached under pressure and cause serious injury. Pos-
sible air leaks can cause faulty pressure readings. Make
sure all connections are tightly secured.
„ Press the power button and a readout will appear on the
gauge.
NOTE: The pressure readout on the gauge while inflating
is a measurement of the fluctuating pressure between the
item and the air hose. To get an accurate reading, release
the power button and wait for the readout to adjust.
„ The gauge will indicate the pressure in PSI. When the
desired pressure is reached, release the power button
and disconnect the inflator.
NOTE: Maximum PSI for this unit is 100 PSI.
NOTICE:
Always leave the hose free of obstructions when the
tool is not in use. Overheating could occur if the hose
is blocked.
„ When finished release the air chuck and remove the
inflated item.
„ Remove the hose from the pump outlet by rotating coun-
terclockwise.
„ Store the hose in the hose storage area on the bottom
of the tool.
6 — English
