MR TAPCON 230 Manual página 22

22
Mounting 7820658/06 EN
To the base of the control cabinet
To the roof of the control cabinet
Between the device and other assemblies on
offset cap rails
Table 2: Minimum clearances in the control cabinet
Figure 11: Minimum clearances
For other installation types, contact Maschinenfabrik Reinhausen GmbH.
5.3 Assembly variants
5.3.1 Flush panel mounting
The device can be mounted in a control panel using tension clamps. The recom-
mended wall thickness is 2...5 mm.
Dimensions for the control panel cutout
Figure 12: Dimensions for the cutout
Minimum clearance: 88.9 mm (3.5 in)
Equivalent to 2RU
88.9 mm (3.5 in)
88.9 mm (3.5 in)
B: 202 mm (7.95 in)