Idiomas disponibles
Idiomas disponibles
assembly with the screws on the caster pad plates, one of which is
located under the heater fins, and the other under the control box.
• As shown in the figure 2, both caster assemblies are tightened with
four butterfly nuts. Tighten them firmly and then place the heater
upright, with the wheels on the ground.
Operating instructions
Inspection before use
• The power cord must not be damaged or broken.
• Please check the rated current of the power socket matches the
requirements in the rating plate and is equipped with a safety
grounding device before use; otherwise, replace the socket.
• Insert the power plug into the socket and turn on the appliance;
after about half an hour, turn it off and pull out the plug. Check
whether the plug pins are hot (more than about 50 °C). If so,
replace the socket to avoid burning the plug or causing a fire due to
overheating of the socket as the result of poor contact.
Start and power selection
1. Start
• Plug in the power cord, turn the thermostat knob clockwise towards
the "+" mark, then turn on the power switch. The heater will begin
operating.
2. Power selection
• Under normal circumstances, please use the maximum power "III"
position for rapid heating. If the room temperature is agreeable,
8
figure 1
Butterfly
nuts
Control
box
figure 2
