Scheppach DP16VLS Traduccion Del Manual De Instrucciones Originale página 30

Taladradora de mesa
Ocultar thumbs Ver también para DP16VLS:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 76
The table below acts as a guide for selecting the proper
speed for various materials.
The drill speeds specified are merely suggested val-
ues.
Drill
Cast
Steel
bit Ø
iron
3
2550
1600
4
1900
1200
5
1530
955
6
1270
800
7
1090
680
8
960
600
9
850
530
10
765
480
11
700
435
12
640
400
13
590
370
14
545
340
16
480
300
Countersinking and centre-drilling
With this table drill, you can also countersink and cen-
tre-drill. Please observe that countersinking should be
performed at the lowest speed, while a high speed is
required for centre-drilling.
Drilling wood
Please note that sawdust must be properly evacuated
when working with wood, as it can pose a health haz-
ard. Ensure that you wear a suitable dust mask when
performing work that generates dust.
10. Transport
The machine may only be lifted and transported on
the belt box and on the frame plate. Never lift it by the
guards or adjusting handles for transport.
For transport, the machine must be disconnected from
the mains.
30 | GB
Iron
Alu-
Bronze
mini-
um
2230-
9500
8000
240
1680
7200
6000
1340
5700
4800
1100
4800
4000
960
4100
3400
840
3600
3000
740
3200
2650
670
2860
2400
610
2650
2170
560
2400
2000
515
2200
1840
480
2000
1700
420
1800
1500
www.scheppach.com
11. Cleaning and Servicing
Pull the mains plug before any adjustments, main-
tenance or repair.
m Have any work on the device that is not de-
scribed in this instruction guide performed by
a professional. Only use original parts. Allow
the device to cool off before any maintenance or
cleaning is undertaken.
There is a risk of burning!
Always check the device before using it for obvious de-
fects such as loose, worn or damaged parts, correct
the positioning of screws or other parts. Exchange the
damaged parts.
• Do not use any cleaning agents or solvents. Chem-
ical substances can etch the plastic parts of the de-
vice. Never clean the device under running water.
• Thoroughly clean the device after every use.
• Clean the ventilation openings and the surface of
the device with a soft brush or cloth.
• Remove chips, dust and dirt with a vacuum cleaner
if necessary.
• Lubricate moving parts regularly.
• Do not allow lubricants to come into contact with
switches, V-belts, pulleys and drill lifting arms.
m WARNING:
Always unplug our tool from power source before any
adjustment".
Setting the laser (Fig. 15, 16)
The laser (13) forms a crosshair in the centre of the
drill. If the laser line does not meet in the centre of the
drill, the laser must be adjusted.
The laser can be adjusted via the adjusting screws (T).
Clamp a drill bit in the chuck (5).
Position the drilling table (3) as close as possible to
the drill.
Loosen the locknuts (W).
It is possible to adjust the laser lines by turning the ad-
justment screws (T).
Set the laser lines such that they cross in the middle
of the drill tip.
loading

Este manual también es adecuado para:

5906810901