Preparation And Set-Up; Set-Up; Setting Time And Date; Insert Cartridge - Reiner jetStamp 792 Manual De Instrucciones

jetStamp 792/792 MP

1. Preparation and Set-up

1.1. Set-up

Only connect the device to the PC after the 790 PCset easy software has been installed
(see "Installing 790 PCset easy-Software", page 56).
Connect jetStamp 792 to the connection electric stamp
f
Connect mains unit to the connection voltage supply
f
Push mains unit into the socket.
f
9
The display shows "INPUT - TIME 1".

1.2. Setting time and date

See "Setting time and date", page 64.
f

1.3. Insert cartridge

When using special ink (MP), observe the notes in the operating instructions.
CAUTION
Health risks if ink is swallowed.
Don't swallow!
f
Keep cartridge out of the reach of children!
f
Insert cartridge Fig.

Remove the jetStamp 792 from the base station
f
Press [MODE] until [INKJET] appears in the display menu bar.
f
Press [INKJET].
f
The print carriage moves into a central position.
Push the locking rail
f
Take the new cartridge
f
16
from nozzles or clip.
When using standard ink hold the small felt pad
f
16
nozzles until some ink appears on the felt.
Holding the cartridge handle
f
Pull the locking bar
f
Press [INKJET].
f
The print carriage moves to the stamping position.
A + C + E
7
as far back as it will go.
6
from its packaging and remove the protective film
10
, insert the cartridge
7
forward again until it locks into place.
14
of the adapter
13
of the adapter
4
.
17
that is provided, against the cartridge
6
into the print carriage.
12
.
12
.
18
51
GB