DeWalt DCF880 Manual De Instrucciones página 12

speed switch enables you to select the best speed for a particular
application. The more you squeeze the trigger, the faster the tool will
operate. For maximum tool life, use variable speed only for starting
holes or fasteners.
NOTE" Continuous use in variable speed range is not recommended.
It may damage the switch and should be avoided.
Forward/Reverse Control Button (Fig. 2)
A forward/reverse control button (B) determines the direction of the tool
and also serves as a lock-off button.
To select forward rotation, release the trigger switch and depress the
forward/reverse control button on the right side of the tool.
To select reverse, release the trigger switch and depress the forward/
reverse control button on the left side of the tool.
The center position of the control button locks the tool in the OFF
position. When changing the position of the control button, be sure the
trigger is released.
NOTE: The first time the tool is run after changing the direction of
rotation, you may hear a click on start up. This is normal and does
not indicate a problem.
Worklights (Fig. 2)
There are three worklights (G) located around the chuck collar (C). The
worklights are activated when the trigger switch is depressed, and will
automatically turn off 20 seconds after the trigger switch is released.
If the trigger switch remains depressed, the worklights will remain on.
NOTE: The worklights are for lighting the immediate work surface and
are not intended to be used as a flashlight.
Quick-Release Chuck (Fig. 2, 5, 6)
NOTE: The chuck accepts 1/4" (6.35 mm) hex accessories and 1"
(25.4 mm) bit tips only.
Place the forward/reverse button (B) in the lock-off (center) position or
remove battery pack before changing accessories.
FIG.5 FIG. 6
To install an accessory, fully insert the accessory. The accessory is
locked into place (Fig. 5).
To remove an accessory, pull the chuck collar (C) away from the
front of the tool. Remove the accessory (Fig. 6).
Anvils
i_WARNING: Use only impact sockets. Non-impact sockets may
break and cause a hazardous condition. Inspect socket prior to use
to ensure that it contains no cracks.
Place the switch in the locked off (center) position or remove battery
pack before changing accessories.
ANVIL WITH HOG RING (FIG. 2, DCF880H, DCF883)
To install a socket on the hog ring anvil, firmly push socket onto
the anvil (J). The hog ring (K) compresses to allow the socket to slide
on. After the socket is installed, the hog ring applies pressure to help
provide socket retention.
To remove a socket, grasp the socket and firmly pull it off.
11