Idiomas disponibles
Idiomas disponibles
English
The R-100277 is a simple polishing lathe especially
designed to polish and grind small items in the field
of dental mechanics.
INSTALLATION
1. Carefuly unpack the unit. Check that it has not
sustained damage during shipment.
It is supplied with the following accessories:
- 1 right-hand thread brush holder.
- 1 left-hand thread brush holder.
- 1 brush Ø48 (R-060440).
- 1 brush Ø80 (R-060420).
- 1 cloth wheel Ø110 (R-060430).
2. Place the unit on a flat and firm surface remote
from any source of heat or vibration.
3. If you are facing the ON switch and wish to fit
the brush-holder on the right-hand end of the
motor shaft, select a right-hand (clockwise)
thread brush-holder, so that the friction torque
produced when the unit is used will help tighten
the brush-holder. If you wish to fit it to the left-
hand end of the shaft, select a left-hand (anti-
clockwise) thread brush-holder.
4. Put one brush holder each side of the polisher
and fix them with the 4 bolts (E).
5. Connect the unit to a 230 V, 50/60 Hz outlet with
earth.
GB
FITTING THE BRUSH TO THE BRUSH HOLDER
Insert the brush into the brush-holder, ensuring
1.
that the brush-holder shaft is perpendicular to
the plane of the brush.
Screw the brush onto the brush-holder as tightly
2.
as possible by hand.
Visually check that the brush-holder shaft is
3.
perpendicular to the plane of the brush by
spinning the assembly in your hand.
Start up the unit: the spin of the motor will reveal
4.
whether the wheel or brush is off line. If there is
more than 2 mm of slip, dismount and re-fit the
wheel-holder or brush-holder.
Remember that the friction torque produced
5.
during work after a brush is fitted to the brush-
holder will keep it tight. This effect can be
favoured by a suitable workpiece attack angle.
CONDITIONS OF USE
For best results use the unit as follows:
• Mount an appropriate brush-holder/wheel-holder
as indicated above.
• Connect the unit to a 230 V, 50/60 Hz power
source.
• Select the desired spin speed (2000-7000 rpm)
turning switch (C).
• Before polishing or grinding a workpiece, check
the motor spin direction, as the initial workpiece
attack angle depends on this. Incorrect attack
angles can be extremely dangerous.
• The
following
recommended for polishing or grind-ing:
- safety goggles;
- safety gauntlets;
- face-mask;
- proper exhausters;
- a
protective
characteristics
TALLERES MESTRAITUA, S.L. recommends
R-080200 or R-080210 screens, which are
especially designed for use with the polisher.
- Proper clothes. No baggy clothes, ties,
necklaces, rings, bracelets or elements that
could be hooked by the machine.
- Be careful with long hair.
- No objects similar to ropes or chains that
Could be hooked by the machine.
• After using the unit, clean the inside of the
protective screen.
protective
equipment
screen
suited
to
and
shape
of
the
is
the
unit.
