Idiomas disponibles
Idiomas disponibles
PREPARATION
No supplied cables are used with these connections:
Please purchase the necessary cables at your local store.
High Speed HDMI cable (also known as HDMI category 2
cable) is recommended for the better compatibility.
Before you connect:
Be sure your antenna or other device is connected properly
before plugging in the AC power cord.
Antenna Connection
Connect the RF coaxial cable on your home outlet to the
antenna input jack of this unit.
e.g.)
e.g.)
VHF / UHF
analog
or
DTV antenna
or
cable TV signal
Once connections are completed, turn on the unit and begin
initial setup. Channel scanning is necessary for the unit to
memorize all available channels in your area.
[Initial Setup] ➠ p. 15
Note
•
If you have any question about the DTV's antenna, visit www.antennaweb.
org for further information.
•
Depending on your antenna system, you may need different types of
combiners (mixers) or separators (splitters). Contact your local electronics
store for these items.
•
For your safety and to avoid damage to this unit, please unplug the RF
coaxial cable from the antenna input jack before moving the unit.
•
If you use an antenna to receive analog TV, it should also work for DTV
reception. Outdoor or attic antennas will be more effective than a set top
or inside antenna.
•
To switch your reception source easily between antenna and cable, install an
antenna selector.
•
If you are not receiving a signal from your cable service, contact the Cable
provider.
rear of this unit
RF coaxial cable
Connection to Cable Receiver or
Satellite Box
Use an HDMI or component video cables to connect the
HDMI or the Component Video Input jacks of the unit to
the HDMI or the component video output jacks of the cable
receiver / satellite box.
If you connect to the unit's Component Video Input jacks,
connect audio cables to the Audio L/R Input jacks right beside
the Component Video connector.
e.g.)
satellite dish
RF coaxial cable
or
cable TV signal
including PPV
HDMI OUT
HDMI cable
or
or
side or rear of this unit
You can also connect this unit to the cable receiver or satellite box
other than the HDMI or the component video output jacks because
they might have different output jacks.
Required cables and connecting methods of the cable receiver /
satellite box, or the availability channel for the clear QAM may differ
depending on the cable / satellite provider. For more information,
please contact your cable / satellite provider.
English
cable receiver /
satellite box
ANT IN
STEREO
PCM
AUDIO OUT
COMPONENT VIDEO OUT
L
R
Y
Pb/Cb
Pr/Cr
or
(green)
(green)
(green)
ree
ree
ree
)
b b (bl )
(b b e)
(blue)
)
( ( d) d
( d)
(red)
red d
red
com m
component video cables
component video cables
component video cables
mponent video o
( ( red/green/blue)
(red/green/blue)
u u
and audio cables
and aud
nd audio cab b
audio ca
i
b b b
es
)
9
EN
