GE GXSF30V Manual De Instrucciones página 7

Before you start.
BEFORE YOU START
The water softener requires a minimum water flow of 3 gallons per minute at the inlet. Maximum
allowable inlet water pressure is 125 psi. If daytime pressure is over 80 psi, nighttime pressure may
exceed the maximum. Use a pressure reducing valve if necessary (Adding a pressure reducing valve
may reduce the flow). If your home is equipped with a back flow preventer, an expansion tank must
be installed in accordance with local codes and laws.
The water softener uses a direct plug-in external power supply (included). Be sure to use the included
power supply and plug it into a nominal 120V, 60 cycle household outlet that is in a dry location only,
grounded and properly protected by an over current device such as a circuit breaker or fuse.
Do not use this system to treat water that is microbiologically unsafe or of unknown quality without
adequate disinfection upstream or downstream of the system.
TOOLS AND MATERIALS REQUIRED FOR INSTALLATION
Pliers Razor knife
Screwdriver
Teflon tape
Two adJustable wrenches
Additional tools may be required if modification
to home plumbing is necessary.
INSPECT SHIPMENT
The parts required to assemble and install the water softener are included with the unit. Thoroughly check
the water softener for possible shipping damage and parts loss. Also inspect and note any damage to the
shipping carton.
Remove and discard (or recycle)all packing materials. To avoid lossof small parts, we suggest you keep the
small parts in the parts bag until you are ready to use them.
WARNING!
Discard all unused parts and packaging material after installation. Small parts
remaining after the installation could be a choke hazard.
NOTE: Failure to comply with these installation instructions will void the product warranty, and the
installer will be responsible for any service, repair or damages caused thereby.
Ground Clamp
Kit
Bypass Valve
0
20ft.
Drain Hose
Clips Installation
Adaptors
Hose Clamps Adaptor
Elbow
Grommet