Idiomas disponibles
Idiomas disponibles
Saw
Operations
Crown Molding Laying Flat on Table
• Notes: Position workpiece with its back flat on the
saw table.
• Always place top edge of molding against fence
(Decorative edge is at the bottom of crown mold-
ing .)
• "Spring angle" refers to angle between wall and
crown molding.
• Cutting crown molding flat on the table can be done
either as a chop cut or a slide cut depending on the
width of the workpiece.
1. For 90 -0 corner, set the bevel and miter angles
using Charts below.
Tighten the miter lock knob
and the bevel lock lever (Figure 35).
2. Position molding on saw table.
Clamp workpiece
in place using the quick clamp.
Use clamping position that does not
interfere
with
operation.
Before
switching on, lower head assembly to make sure
clamp clears guard and head assembly.
3. Follow procedures for either chop cut or slide cut
(see page 23).
4. Wait until blade comes to a complete stop before
returning
head assembly
to the raised position
and/or removing workpiece.
NOTE:
ALWAYS
TAKE
A TEST
CUT
USING
SCRAP TO CONFIRM CORRECT ANGLES.
Quick-Action
Clamp
Crown
Molding
33.9 ° Bevel
31.6 ° Miter
Figure 35. Crown Molding Laying Flat
Miter and Bevel Settings
for Standard
Crown Molding
Cuts
(When Crown Molding is Lying Flat on Table)
Assumptions:
Molding is milled consistently. Corner is exactly 90 -0 .
Molding Spring Angle is 38 degrees
Miter
Bevel
(Table)
(Tilt)
Setting
Setting
Inside Corner
Left end (A)
Use the left end of the cut
(31.6) Right
(33.9) Left
Right end (B)
(31.6) Left
(33.9) Right
Use the right end of the cut
Outside
Corner
Left end (C)
(31.6) Left
(33.9) Right
Use the left end of the cut
Right end (D)
(31.6) Right
(33.9) Left
Use the right end of the cut
Molding Spring Angle is 45 degrees
M iter
(Table)
Setting
Inside Corner
Left end (A)
Use the left end of the cut
(35.3) Right
Right end (B)
Use the right end of the cut
Outside
Corner
Left end (C)
Use the left end of the cut
(35.3) Left
(35.3) Left
Right end (D)
(35.3) Right
Use the right end of the cut
Bevel
(Tilt)
Setting
(30.0) Left
(30.0) Right
(30.0) Right
(30.0) Left
29.
