Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR THE USER
EXTRAORDINARY MAINTENANCE
The oven requires small maintenance interventions should, in time, those parts subject to wear, such as gaskets, lamp, etc., require replacing.
Instructions for these types of interventions are supplied below.
Disconnect the oven power supply before every intervention that requires access to live parts.
Replacement of the internal lamp
Remove protection cover A by unscrewing it anti-clockwise,
replace lamp B with a similar one (see figure on the side).
Mount the protection once again and screw it clockwise until it is tight.
Only use oven lamps (T300 °C) 15W./25W depending on models.
Never touch the lamp with bare fingers, always use protective gloves.
Only use lamps obtained from authorised after-sales centres.
Dismantling of the door
Lift levers "1" up to the ledge with hinges "2" and hold the door at the two sides with both hands near the same hinges. Lift the door upwards
forming an angle of approx. 45° and carefully extract it. For the mounting, place hinge "2" in the appropriate grooves, therefore leave the door to
lean downwards, ensure it remains blocked in grooves "3", then release levers "1" (figure on the side).
Dismantling of the oven door gaskets
To better clean the oven, the door gasket can be removed. Before removing the gasket it is
necessary to dismantle the oven door as described in paragraph 4.8 "Dismantling of the door".
With the door dismantled, lift the tabs located in the middle and at each corner, as shown in the
figure. Once cleaning is completed, re-mount the gasket keeping the longest side horizontal and
place the tabs in the respective holes, starting from the upper ones.
Disassembling the shelf supports
1. First slide the extraction guide out of the side wall by pulling it forwards.
2. Slide the rear extraction guide out of the side wall and remove it.
1
2
1
2
To reinstall the supports, follow the procedure indicated in reverse.
EN
30
