Idiomas disponibles
Idiomas disponibles
English
NOTE
When using the saw at the inclination of 45 degrees,
use both the marks of on the bevel plate and [45] on
the inclined gauge of the base (Fig. 32).
What's more, if it is absolutely essential to use the
saw at a precise angle, make adjustment using a
protractor, etc.
Incline lever
(3) Ensure that the switch is turned to the ON position
before the saw blade comes in contact with the
lumber. The switch is turned ON when the trigger
switch is squeezed; and OFF when the trigger switch
is released. Moving the saw straight at a constant
speed will produce optimum cutting.
26
Cutting line
(at 45 degrees)
Fig. 31
Bevel plate
Inclined gauge
Fig. 32
[POCKET CUTTING]
WARNING
● To avoid serious accident, ensure the switch is
OFF position, and disconnect the plug from the
receptacle before any adjustment.
● Never tie or wedge the lower guard in a raised
position.
1. Mark the desired cutting area clearly with lines all
side. (See Fig. 33)
2. Set depth adjustment according to material to be cut.
3. Push the lower guard lever all the way back so the
blade is exposed as shown in Fig. 33.
4. Tilt saw forward and align the notch (Fig. 29) with the
pre‑marked guide line.
5. Release the lower guard lever. When the lower guard
contacts the work piece surface, it will be in proper
position to open freely when cutting is commenced.
6. Holding the saw in position, with the blade not
contacting the work piece surface, pull the trigger.
7. After the saw has reached full speed, gradually lower
rear end of the saw until its base rests on the work
surface.
8. Advance saw along the cutting line up to the corner.
9. Release trigger and allow blade to stop completely
before withdrawing the blade from the work piece.
○ Never under any circumstances pull the saw
backwards while the blade is in motion, as kickback
may result.
10. Use a jig saw or hand saw to cut the corners out
clean.
11. When starting each new cut, repeat as above.
Lower guard
lever
Fig. 33
