Idiomas disponibles
Idiomas disponibles
Saw blade
12. Cutting procedures
WARNING
● Recheck that the saw blade is securely clamped.
● Confirm that the lever for adjusting the angle of
inclination and the lever for adjusting the slot
depth are adjusted correctly.
● Don't remove the power tool from workpiece
during a cut while the saw blade is moving.
● When finished with a job, pull out the battery
from the main body.
● To avoid abnormal heating of the blade tip or
damage to the saw blade, do not twist or apply
excessive force to the saw blade when cutting.
Let the blade move forward smoothly.
CAUTION
In the situation where the power tool is
continuously operated while replacing the
battery with stocked spare batteries one after
another, the motor tends to overheat. Therefore,
whenever the housing becomes hot, give the
power tool a break for a while.
NOTE
○ Before starting to saw, ensure that the saw blade has
reached full speed revolution.
○ Avoid cutting operation in a state where the base
bottom is afloat from the material being cut.
Otherwise, the motor can get locked.
○ Do not press the lock lever while the motor is running,
as it will lock the spindle in place.
(1) Place the base on the material, then align the
premarked line and the saw blade with the notch at
the front of the base (Fig. 29).
Lumber
Guide
Fig. 28
When Inclined 45°
(2) When the base is not inclined, use the right side of the
notch (Fig. 29, Fig. 30).
If the base is inclined (45 degrees), use the left side of
the notch (Fig. 29, Fig. 31).
English
When not
Inclined
Fig. 29
Fig. 30
25
