Weller WHA 3000P Traducción Del Manual Original página 49

Nozzle change
Caution: Risk of burns! The hot air nozzle remains hot for some time after power off or
removal.
The hot air nozzles are fastened to the heating element using a clamping screw. To change the
nozzle, loosen the screw and remove the hot gas nozzle using the Nozzle Change Tool provided.
8. Maintenance
The vacuum filter (15) is soiled by flux residues and contaminants and must be replaced if the
vacuum drops.
9. Error messages
Error
ERROR 75
ERROR 76
ERROR 110
REMOTE
LOCKED
TOOL STAND
10. Accessories
0053119099
0058754951
0058757770
0058736780
0051504899
WBH3000
WBH3000S
WHP3000
11. Items supplied
WHA3000P Controller with hand-piece
AKT30 Safety stand
0051504999 Nozzle exchange tool
Coded plug
Tool kit (2,5 mm hex wrench w/2 3 mm x 6 mm L screws provided)
0058750721 Hot air nozzle NQ30
Main power cord 120VAC
0058757770 Foot switch (Only USA Version)
Product CD- Rom (Operating instructions incl. WHA control software)
Subject to technical change without notice!
Description
Offset entry on heating element change incorrect Repeat process
Heating element faulty
WHP3000 housing temperature exceeded
Input inhibited (can only be operated using PC)
WHA locked (lock function)
AKT30 Stand (or WBH3000 Proximity Sensor)
not connected
External sensor type K ∅ 0.5mm
External sensor type K ∅ 0.25mm
Foot switch
Manual Control Console
Stand for six hot air nozzles
Circuit board holder
Circuit board holder with hot air tool stand
Bottom heating plate
Rectification
Replace heating element
Allow to cool down
Operate using PC
Unlock WHA
Connect to socket (17)
Page 12 of 14
47