Idiomas disponibles
Idiomas disponibles
SYMBOLS
The label on your tool may includethe following symbols. The symbols and their definitions are as follows:
V,.................
volts
Hz ................
hertz
min ..............
minutes
- - = or DC,,, direct current
(_) ................
Class I Construction
(grounded)
[_ ................
Class II Construction
(double
insulated)
............ Read instruction manual before use
................
Use proper
eye protection
A ...................
amperes
W ..................
watts
r_Jor AC ....... alternating
current
no .................. no load speed
_, .................. earthing
terminal
/_ ................ safety alert symbol
,,,/min or rpm,,,revolutions
or
reciprocation
per minute
..................
Use proper respiratory
protection
0 ..................
Use proper hearing
protection
iMPORTANT
SAFETY
iNSTRUCTiONS
FOR BATTERY
CHARGERS
SAVE THESE
iNSTRUCTiONS:
THiS MANUAL
CONTAINS
iMPORTANT
SAFETY
iNSTRUCTiONS
FOR BATTERY
CHARGERS.
• Before using charger,
read all instructions
and cautionary
markings
on charger, battery pack, and
product using battery pack.
z_WARN_NG:
SHOCK
HAZARD.
Do not allow any liquid to get inside charger.
z_OAUT_ON:
BURN
HAZARD.
To reduce the risk of injury, charge
only designated
Craftsman
C_
batteries.
Other types of batteries
may burst causing
personal
injury and damage.
z_OAUT_ON:
Under certain conditions,
with the charger
plugged
in to the power supply, the
charger can be shorted
by foreign
material.
Foreign
materials
of a conductive
nature such as, but not
limited to, steel wool, aluminum
foil, or any buildup
of metallic particles
should
be kept away from
charger cavities.
Always unplug the charger from the power supply when there is no battery pack in
the cavity. Unplug charger
before attempting
to clean.
z_WARNING:
THE CHARGER
SUPPLIED
WiTH THiS PRODUCT
iS iNTENDED
TO BE
PLUGGED
IN SUCH THAT
iT iS CORRECTLY
ORIENTATED
iN A VERTICAL
OR FLOOR
MOUNT
POSiTiON.
• DO NOT attempt
to charge
the battery
pack with
any chargers
other than the ones in this
manual.
The charger and battery pack are specifically
designed
to work together,
• These
chargers
are not intended
for any uses other
than charging
designated
Craftsman
®
rechargeable
batteries.
Any other uses may result in risk of fire, electric shock or electrocution,
• Do not expose
charger
to rain or snow.
• Pull by plug rather than cord when
disconnecting
charger.
This willreduce
risk of damage
to
electric plug and cord,
• Make sure that cord
is located
so that it will not be stepped
on, tripped
over, or otherwise
subjected
to damage
or stress.
• Do not use an extension
cord
unless
it is absolutely
necessary.
Use of improper
extension
cord
could result in risk of fire, electric shock, or electrocution,
• An extension
cord
must have adequate
wire size (AWG or American
Wire Gauge)
for safety.
The smaller
the gauge number of
the wire, the greater
the capacity
of
the cable, that is 16 gauge has more
capacity
than 18 gauge.
When using
more than one extension
to make up
the total length, be sure each individual
extension
contains at least the minimum
wire size.
Minimum Gauge for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50
51-100
101-150
(0-7,6m)
(7,6-15,2m) (15,2-30,4m)(30,4-45,7m)
240V
0-50
51-100
101-200
201-300
(0-15,2m) (15,2-30,4m)(30,4-60,9m)(60,9-91,4m)
Ampere
Rating
More
Not more
American Wire Gauge
Than
Than
0
6
18
16
16
14
6
10
18
16
14
12
10 -
12
16
16
14
12
12 -
16
14
12
Not Recommended
