Kenmore PG-40406S0L Manual De Uso Y Cuidado página 27

Side Burner
9
 Unscrew and remove the two front screws and washers holding the side burner in place. (A)
Remove the side burner from the side shelf. (B) Note: Do not loosen the electrode screw.
 Remove the 2 pre-installed screws from the valve stem and set them aside. (C)
 Insert the valve stem through the hole in the fascia. (D) Install the previously removed 2 screws.
Note: Leave a 1/8-inch gap below the screw heads for the bezel attachment. (E)
 Attach the bezel to the fascia and the installed screws. Make sure the black mark is facing up.(F)
Tighten the 2 screws. (G)
 Place the side burner tube over the valve, making sure that the valve is inside the side burner tube. (H)
 Reattach the side burner to the side burner shelf with the 2 previously removed screws.
Place back the side burner grate. (I)
 Push the control knob onto the side burner valve stem. (J)
 Connect both igniter wires to the igniter module on the inside of the right fascia.
To connect, push the igniter wire tips onto the pins in the igniter module. (K)
 Unscrew the igniter cap from the right fascia. Insert (1) AA battery (provided in the blister pack) into
the battery slot with the positive end (+) facing outward. Screw the igniter cap back onto the right
fascia. (L)
27