Idiomas disponibles
Idiomas disponibles
Installation of appliance
5
(Figure 1)
1. Flap Pin Socket
2. Flap Pin
Insert the plastic pin (Figure 1/area no. 2) on the
pin socket on the motor exhaust (Figure 1/area
no.1). Then bend the flap lightly to insert the other
pin on the flap and insert the other pin to its socket
(Figure 1).
(Figure 2)
By using the 4 x 40 screws provided with the hood,
install the appliance to the cabinet from the points
A, B, C and D. When the slider set moves, the front
panel shall not rub on the cabinet door (Figure 2)
Cooker Hood / User Manual
(Figure 3)
Install flexible aluminium pipe to plastic flue outlet.
Install the other end of the pipe to the flue hole on
the wall (Figure 3).
5.4 Connecting to flue
If you are going to use the Ø 120/150 mm plastic
flue adapter, connect one end of the pipe to this
adapter, if you are not going to use it, to the direct
output on the product. Connect the other end of
the pipe to your flue. Check that these two con-
nections are tight enough so they will not come out
when the appliance runs on full power. Ensure that
the flaps inside the flue work when tightened with
clamp. Connect the flue connection duct outside
the adapter. If the connection duct is fitted inside
the adapter, the covers that prevent air return shall
remain closed and air won't be sucked in. The
length of the pipe connection as well as the num-
ber of elbows must be as minimum as possible.
13 / EN
